Laboratoire Léon Brillouin

UMR12 CEA-CNRS, Bât. 563 CEA Saclay

91191 Gif sur Yvette Cedex, France


Let's scatter neutrons

Apr 19, 2011
Magnetocardiography with GMR (giant magnetoresistance) sensors

Measurement of the cardiac electrical activity allows following the heart dynamics. Usually measured with electrodes during an electrocardiogram (ECG), this activity can also be studied by monitoring the magnetic component, induced by the circulation of the heart electric currents. This is called "magnetocardiography (MCG). The exquisite sensitivity of the new magnetic sensors made ​​in IRAMIS / SPEC will contribute to the emergence of this technique, which has the advantage of being contactless, therefore requiring no electrodes and allowing a dynamic imaging of the cardiac cycle by a mapping of the signal.


The magnetic signals generated by the cardiac activity are of very low amplitude (tens of picoteslas ~ 10-12 T) and only extremely sensitive magnetometers like SQUIDs [1] (Superconducting Interference Devices) allowed up to now such precise measurements.

The sensitivity is the key parameter to measure such low signals, and new sensors developed in IRAMIS/SPEC on the principle of spin electronics are used to perform magneto-cardiography measurements. The principle of these sensors is to associate a magnetic field sensor, based on the giant magnetoresistance effect, and a superconducting loop capturing the magnetic flux [1]. With this device, sensitivities of the order of several femtoteslas (~ 10-15 T) are achieved.

[1] A SQUID (Superconducting Interference Device) is an electrical circuit made of two branches forming a superconducting ring; each branch includes a thin insulating barrier (Josephson junction). The voltage difference measured across the branches is function of the magnetic flux through the ring, which is quantified.

Magnetocardiography with GMR (giant magnetoresistance) sensors

Schematic representation of a hybrid sensor: four giant magnetoresistance sensors (GMR, dark blue) are arranged on the constriction of a superconducting loop (light blue). The change in voltage (and therefore resistance) of GMR depends on the magnetic field applied to the loop. Constriction is about 5 microns wide and the main loop size is about 20 mm.

Magnetocardiography with GMR (giant magnetoresistance) sensors

The experiment was performed in the MEG shielded magnetic chamber of Neurospin (CEA-DSV/INSERM). The measurement system (sensor cooled in a fiberglass cryostat) is positioned above the chest of the volunteer. The measured signal is amplified on two stages and sent to the acquisition chain. The measurement is completely passive for volunteers and requires no contact.

The measurement was performed on healthy adult volunteers in the shielded magnetic chamber in Neurospin (DSV), allowing the elimination of the major part of the external magnetic disturbances. The signal was recorded without contact along a grid positionned above the subject's torso. From the set of individual measurements, it is possible to plot the isocontours of the magnetic field, and then to locate and get the amplitude of the current dipole associated to the different times of the cardiac cycle.

Following the measurement principle thus established, it is now possible to design a clinical MCG. It could contain a network of 25 to 36 magnetic sensors that will achieve in a very short time, typically one minute, a dynamic image of the electrical activity during the cardiac cycle. In addition, the combination of information received by all sensors would allow reducing the ambient magnetic noise, even in an unshielded environment, by means of the signal analysis techniques developed for magneto-encephalography (MEG).

Cartographie en magnétocardiographie
Above, the magneto-cardiography signal recorded by the hybrid sensor. Below, maps of magnetic field isocontours, measured at several points (blue: negative component of the field, red: positive component) at two different times of the cardiac cycle (segment QR at 300 ms and T wave at 650 ms). From these maps, the position, orientation and amplitude of the current dipole (green arrow) can be deduced.


Magnetocardiography with sensors based on giant magnetoresistance,
M. Pannetier-Lecoeur, L. Parkkonen, N. Sergeeva-Chollet, H. Polovy, C. Fermonand C. Fowley,
Applied Physics Letters 98 (2011) 153705.

 Applied Physics Letters

[1] Femtotesla magnetic field measurement with magnetoresistive sensors
M. Pannetier, C. Fermon, G. Le Goff, J. Simola, and E. Kerr,
Science 304 (2004) 1648.

 Science Mag


Contact : Myriam Pannetier-Lecoeur.

#1794 - Last update : 04/29 2011


Retour en haut